Baby Lock Crescendo BLCR, Инструкция и справочник

Страница: 47 / 216

UPPER THREADING
G
ettin
g R
ea
d
y
Basic operations B-45
B
1
m
Press the “Automatic Threading” button to
have the machine automatically thread the
needle.
→
The thread passes through the eye of the needle.
n
Carefully pull the end of the thread that was
passed through the eye of the needle.
* If a loop was formed in the thread passed through
the eye of the needle, carefully pull on the loop of
thread through to the back of the needle.
o
Pull out about 10-15 cm (approx. 4-6
inches) of the thread, and then pass it under
the presser foot toward the rear of the
machine.
→
Raise the presser foot lever if the presser foot is
lowered.
a
About 10-15 cm (approx. 4-6 inches)
Memo
• When the “Automatic Threading” button is
pressed, the presser foot will be
automatically lowered. After threading is
finished, the presser foot moves back to the
position before the “Automatic Threading”
button was pressed.
Note
• Pulling the loop of thread gently will avoid
needle breakage.
Memo
• If the needle could not be threaded or the
thread was not passed through the needle
bar thread guides, perform the procedure
again starting from step
c
.
Then, pass the thread through the eye of
the needle after step
i
.
Note
• Some needles cannot be threaded with the
needle threader. In this case, instead of
using the needle threader after passing the
thread through the needle bar thread guide
(marked “6”), manually pass the thread
through the eye of the needle from the front
to the back.