Baby Lock A-LINE Lauren BL450A, Инструкция и справочник

Страница: 6 / 28

4
Oiler Brush
Screw
Driver
Rolled Hem
Needle Plate
Thread Nets
Accessory Case
Power Line
Plug
Foot
Control
ELECTRICAL CONNECTION
Connect the electrical cord to the machine by inserting the three-
hole plug into the terminal box located on the right side of the
machine.
Connect the cord plug into an electrical outlet.
POLARIZED PLUG INFORMATION
This appliance has a polarized plug (one prong wider than the
other). To reduce the risk of electric shock, this plug is intended to
fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not modify the plug in any
way.
Light and
Power
Switch
LIGHT AND POWER SWITCH
The light and power switch is located on right side of machine in front of the terminal box. To turn power on, push
the front side of the switch.
Turning on the power, lights up the stitching area. The machine will not operate unless the switch is on.
FOOT CONTROL (Model YC-482)
This foot control was designed exclusively for this machine, and is not to be used on any other machine, nor
should any other foot control be connected to this machine.
Place Foot control on floor where it is easy to reach with your foot.
To make machine go faster, press down on foot control; to slow down the sewing speed, let up slightly on the foot
control.
CAUTION:
Disconnect the electrical cord from the wall outlet when machine is not in use or when it is being cleaned.
Turn the power switch to the “OFF” position before changing needles or needle plates, and before connecting
the cord. This will help prevent accidents.
Needles
ELx705/Organ HAx1
(#11 x 2)
(#14 x 3)
Thread Caps
Extra Lower
Blade
Tweezers
Subsidiary
Looper Case
Subsidiary
Looper
(for 2-thread
sewing)
Blind Hem
Presser Foot
ACCESSORIES
Allen
Wrench