BA Pumps & Sprayers TSX400 Series, Безопасные методы работы, Страница: 13 / 18

0800 833 538 www.bapumpsandsprayers.com
Oil Change:
Change oil after the first 500 hours as follows:
- Remove the tank plug and the drain plug
- Rotate the shaft to remove excess oil
- Wash inside the parts with Diesel oil
- Refill pump with oil through the glass and rotate the shaft to distribute oil and fill to the
proper level
- Start pump and let run for a few minutes at zero to facilitate the correct lubrication of
inside parts
-
USE ONLY “SAE 30” OIL
For all pumps without the drain plug normally oil is changed whenever the wear parts (like
diaphragms, o-rings, valves assembly) are changed. Always perform this routine
maintenance on the pump at the end of the season. Drain the oil from the pump by
removing the pump heads one by one and the relevant piston sleeves.
Instructions for the correct use of the Pressure Regulation Valve:
1. Start the pump only when valve is in the “by-pass” position, let it run for at least two
minutes and, in any case, until air has been vented from the hydraulic circuit.
2. Turn the valve lever clockwise to “Press” position, close the spray gun or spray boom, turn
the adjustment knob clockwise up to the working pressure selected, open the spray gun or
spray boom and start spraying.
Routine maintenance on the pump includes changing the diaphragms, oil, valves assembly,
O-rings, all of which are normal wear parts.
BYPASS
PRESS