B52 DV-8772, Инструкция по эксплуатации

Страница: 25 / 80

25
1. Dashboard
2. Nut (5mm)
3. Spring Washer
4. Screw (5 x 25mm)
5. Screw
6. Strap
Be sure to use the strap to
secure the back of the unit in
place. The strap can be bent by
hand to the desired angle.
7. Plain Washer
INPUT THE SD CARD
The SD oblique andle keeps upward
exposure put into the SD slot and
press it again to eject.
1. Frame
2. Insert fingers into the groove in the front
of frame and pul l out to remove the frame.
(When reatt achi ng the frame, point the
side with a Groove dow nwards and attach
it. )
3. Lever
Insert the levers supp lied with the
unit into the grooves at both sides of
the unit and shown in figure until they click.
Pulling the levers makes posible to remove
the unit from the dashboard.
Fastening the unit to the factory radio
mounting bracket:
1. Select a position where the screw holes
of the bracket and the screw holes of the
main unit become aligned (are fitted), and
tighten the screws at 2 places on each side.
Use either truss screws (5x5mm) or flush
surface screws (4x5mm).
2. Screw
3. Dashboard or console
DIN REAR-MOUNT (Method B)
Installation using the screw holes on
the sides of the unit.
UNIT INSTALLATION
1
2
3
4
5
6
7
(
Fig
.
2
)
2
1
3
(
Fig
.
3
)
Removing the uni t
2
3
2