zero1
strapped Speaker Wiring master / Slave
9
To link the master and slave amplifier speaker connection follow the steps below.
step 1.
Run the
positive (+)
speaker cable from the
master
amplifier’s speaker output to the
positive terminal (+)
of the subwoofer.
step 2.
Run the
positive (+)
speaker cable from the
slave
amplifier’s speaker output to the
negative terminal (-)
of the subwoofer.
Step 3.
Connect both amplifiers together by running a cable from
negative
speaker output on
master
amplifier
to
negative
speaker output on
slave
amplifier. Use minimum 8 GA cable for connecting the amplifiers.
Speaker impedance 2 Ohm ~ 16 Ohm
Loads under what is specified will cause excessive heat & the amplifier
will reach thermal at a faster rate & will eventually go into protect.
Strapped impedance load under 2 ohm is not warranted!
BASS
BOOST
0dB 9dB
BASS
FREQ
30Hz 80Hz
MASTER
SLAVE1
SLAVE2
SWEET LIKE DANISH
Head unit
MASTER AMPLIFIER
SLAVE AMPLIFIER
Speaker Impedance 2~ 8 ohms
BASS
BOOST
0dB 9dB
BASS
FREQ
30Hz 80Hz
MASTER
SLAVE1
SLAVE2
SWEET LIKE DANISH
Linking or strapping makes 2 amplifiers work as a single amplifier. This configuration will near double the rated
output power. Follow the instructions carefully as it can cause harm to your system if done incorrect.
To enable this function, let the master amplifier switch next to the phase knob stay in “OUTPUT MASTER”.
On the slave amplifier, this switch shall be in “INPUT SLAVE”.
Run a RCA cable from the master amplifier’s “RCA OUT”.
Connect the other end of the RCA to the slave amplifier’s “RCA IN” located next to the “INPUT SLAVE” switch
