- 8 -
- 9 -
NOTES ON THE POWER SUPPLY:
Connect the +12V power input lead only after all other leads have been connected.
Be sure to connect the ground wire of the unit securely to a metal part of the car.
A lose connection may cause a malfunction of the amplifier.
REM: The unit is turned on by ap12 Volts to this terminal. This terminal does
not draw heavy current like the tow Power Terminals so a thinner connecting wire is
acceptable. Standard 18 GAUGE is fine and the standard color is yellow. If the radio is
equipped with a Power Antenna control wire, it can drive this terminal. If the Power
Antenna wire is already in use, you can still splice into it. With this method, the unit will
turn on automatically with the radio.
Use the power supply lead with a fuse attached whose value is the same as original
fuse.
Place the fuse in the power supply lead as close as possible to the car battery.
During a full power operation, Maximum current will run through the system.
Therefore, make sure that the leads to be connected to the +12V and GND terminals
of the unit respectively must be larger than 8-Gauge (AWG.8).
BATTERY
DC 12V
To a metal part of car
HEAD UNIT
FUSE
(+12V)
SENS OUT
SPEAKERS CONNECTIONS
POWER CONNECTION LEADS
BRIDGED MODE
CH1 SPEAKER
2~4 Ohm
CH2 SPEAKER
2~4 Ohm
SPEAKERS CONNECTIONS
BRIDGED
+12V REM GND
CH3
CH4
CH1
CH2
FUSE
CH3 SPEAKER
2~4 Ohm
CH4 SPEAKER
2~4 Ohm
SPEAKER
4~8 Ohm
BRIDGED
+12V REM GND
CH3
CH4
CH1
CH2
FUSE
SPEAKER
4~8 Ohm
1000.
4
FOUR CHANNEL