B.Well WA-22H, Инструкция по эксплуатации

Страница: 14 / 34

11
6. Error messages/malfunctions 6. Error messages/malfunctions
If an error occurs during a measurement, the mea-
surement is discontinued and a corresponding error
code is displayed (Example: Error No. 1).
Error No. Possible cause(s)
«Err 1» No pulse has been detected.
«Err 2» The inflation of the cuff takes too long. The cuff is not correctly seated.
«Err 3» Unnatural pressure impulses influence the measurement result. Reason: the arm
was moved during the Measurement (Artefact).
Other possible malfunctions and their elimination
If problems occur when using the device, the following points should be checked and if necessary,
the corresponding measures are to be taken:
Malfunction Remedy
The display remains empty when the
instrument is switched on although the
batteries are in place. 1. Check batteries for correct polarity and if
necessary insert correctly.
2. If the display is unusual, re-insert batteries or
exchange them.
The device frequently fails to measure
the blood pressure values, or the values
measured are too low (too high). 1. Check the positioning of the cuff.
2. Measure the blood-pres sure again in peace and
quiet under observance of the details made under
point 5.
Every measurement results in different
values, although the device functions
normally and normal values are displayed. 1. Please pay attention to the following information
as well as the points listed under «Common sources
of error» and repeat the measurement.
The blood pressure values measured differ
from those measured by the doctor. 1. Record the daily development of the val ues and
consult your doctor about them.
wa-22h.indd 11 13.04.2006 16:10:43