DD700 TCP/IP Ethernet Card Setup Instructions
Initially set the computer’s Ethernet
port to Obtain IP address automatically
to allow digi device discovery detect
the port. If you are setting up each
device with a static IP address, change
your computers Static IP address in the
same range. This will be entered on the
same screen shown on the left. The
last number should be unique from the
others.
4.
Open Digi Device discovery. The digi program should find Ethernet card in DD700 with default IPaddress,
Subnetmask, gateway, port.
Note: If the Digi Device web interface will not open in Internet Explorer check the settings in the
following: open Internet Explorer click on tools, Internet options, connections, LAN settings, uncheck
box in proxy server section if box is checked.
5.
Choose open web interface displayed in the list of found devices.
6.
Enter username:
admin
password:
cbadmin
7.
Under configure choose network. This is where you can change IP address, subnetmask, gateway.
8.
To change port# choose serial port
9.
Click on port 1
10.
Find TCP port type in the port # you want data streaming from.
11.
Click Apply.
12.
You will now need to change your computer’s Ethernet port
to a static IP address if you set up the card with a static
address. Make sure the fourth IP address number is different
from the other devices on your network.
B-TEK Scales, LLC • 1510 Metric Ave. SW Canton, OH 44706 • Toll Free: 800.266.8900 • Fax: 330.471.8909
