B-TEC IR-B01, Руководство пользователя

Страница: 11 / 11

11
7. Troubleshooting
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
SOLVENT
POPPING Unit too close to panel Move unit further away
Insufficient flash off time Increase flash off time
Paint system has a fast reducer Use a standard or slow reducer
UNDER CURE
OR SOFTNESS
OF THE PAINT
FILM
Unit too far away Move unit closer
Insufficient bake time Increase full bake time
Excessive film weight Apply lighter coats
SOFTNESS ON
EDGES OF
REPAIR Repair too large for I.R. unit Split area into two, move unit for
2nd application. If flash off is
used, it will not be necessary on
second
application
DIFFICULTY IN
POLISHING
OUT DIRT NIBS Too long on bake cycle Reduce cure time
Unit too close to panel Move unit further away
UNEVEN CURE IR cassettes not shaped to
contours of repair
Adjust IR cassettes for even heat
distribution
For optimal baking performance, we recommend that users should obtain either B-TEC
SYSTEMS
paint curing data, or consult the paint companies’ recommendations. A general
guide is supplied on page 9.
IF IN ANY DOUBT ABOUT ASSEMBLY OR OPERATION OF THE
UNIT PLEASE DO NOT HESITATE TO CONTACT YOUR
DISTRIBUTOR OR THE B-TEC SYSTEMS SERVICE DEPARTMENT
AT (480) 621-5304.
Above specifications and diagrams are subject to revision. B-TEC Systems reserves the right
to make any changes without notification.