B-Speech®Nemo
Manual
with the headset.
7. Your phone will advise you that the pairing is successfully, and the LED on your headset will
change its state to show that it’s now in standby mode. The blue LED will flash every 3
seconds depending on the profile your cell phone supports.
8. If the pairing fails, the blue LEDs keep blinking rapidly. Please repeat steps A to G to pair the
headset and the phone again.
NOTE: The display on the mobile phone will also give the status. Once the headset and phone have
been successfully paired, you are ready to make and receive calls.
Turning your headset ON and OFF
To switch your headset on, press the Talking button (the bigger one) for about 3 seconds until the
blue LED quickly flash 5 times
To switch your headset off, press and hold the Talking button (the bigger one) for 3 seconds until the
blue LED flashes 5 times.Then the headset will turn off.
Answering a call
If there is an incoming call, a ring tone will sound in your headset; please press theTalking button
(the bigger one) on the headset to answer the call.
If your cell phone supports auto-answering, the headset will take the incoming call automatically and
you don't need to press any button.
Ending a call
When in conversation, you can press and hold the Talking button (the bigger one) for 1 seconds
to end the call. You can also end the call by pressing the END button on the cell phone. When the
other party hangs up, the headset ends the call automatically.
3 / 6
