No air is being blown out of the Air
Outlet.
Remove odour and decompose
formaldehyde, VOCs and other
harmful pollutans.
Trouble Shooting
Problem
Solution
Unit does not operate
.
Make sure all packaging materials are removed.
Unit produces abnormal noise.
Make sure all packaging materials are removed.
14
Product Specification
Power Supply
DC5V 2A
Power
Consumption
(W)
Mode
Lowest
1.3
Highest
2.5
Airflow
Volume
(m³/hr)
Mode
Lowest
12
Highest
25
Noise
Level
(dB)
Mode
Lowest
40.6
Highest
44.9
0.96
Product Dimension
(L × W × H) (mm)
160 (L) x 160 (W) x 88 (H)
Net Weight (kg)
Treatment System
Active Oxygen
Generator
HEPA Filter
NCCO Reactor
Sterilization & Disinfection
15
Check whether the unit is correctly connected to its power supply.
(
Please refer to page 8 for the correct method of connecting the
power supply.
)
Turn on unit
.
Check whether the unit is correctly connected to its power supply.
Turn on unit
.
Immediately switch off unit and disconnect its power source. Call
the customer service center immediately or contact with a qualified
service provider.
‘DiDiDi’ sound is heard and unit
does not operate.
Check whether the filters have been correctly installed. Re-install
filters.
The air quality has not improved
after a long operation time.
If the unit is used in a seriously polluted area, the treatment
process will take longer than normal. It is recommended to
operate the unit using it high airflow mode until the pollution
diminishes.
Filters might require cleaning or replaced
.
Clean or replace filters
.
Airflow speed at Air Outlet becomes
slow.
Filter may be blocked.
Replace the filter. (For the method to install filters, please refer to
Page 7.)
Make sure Air Inlet and Air Outlet are not blocked by foreign matter.
The unit may be malfunctioning – Seek advice from service centre
or an authorised service provider.
Unit emits unusual smell, odour or
smoke (also flames or burning).
Removes dust, hair, and airborne
particles such as allergens, pollen,
bacteria, viruses and fungus.
