pa R t S i n c L u D e D :
•
Filter system with filter cartridges
•
Installation hardware (mounting screws, saddle valve, fittings)
•
6.35 mm (1/4-inch) tubing
•
Lead-free faucet
tools and Materials Required:
•
Safety Glasses
•
Hand or electric drill
(cordless recommended)
•
File
•
Phillips head screwdriver
•
2 adjustable wrenches
•
Tube cutters or utility knife
If sink does not have hole for separate faucet:
•
Center punch – 19mm (3/4-inch) drill bit
p R e c a u t i o n S :
•
Protect filters against freezing, which can cause cracking of the filter and water leakage.
•
The rubber O-ring provides the water-tight seal between the cap and the bottom of the housing.
It is important that the O-ring be properly seated in the groove below the threads of the housing or a
water leak could occur.
•
To prevent costly repairs or possible water damage, the sump of plastic housings must be replaced
every five years for clear, and ten years for opaque. If sump is older than recommended, replace
immediately. Date sump for reference and indicate replacement date.
note:
•
For cold water use only.
•
Make certain that installation complies with all local laws and regulations.
•
After prolonged periods of non-use (such as during a vacation) it is recommended that the system be
flushed thoroughly. Let water run for 5-6 minutes before using.
•
The filter cartridges used with this system have a limited service life. Changes in taste, odor, and/or
flow of the water being filtered indicate that the cartridges should be replaced.
9333
Nanotechnology Under Counter Water Purification System
2
Hel neu st 57
