B-CURE Laser Pro, Инструкция по эксплуатации

Страница: 14 / 20

14
7.2 Treatment course and dosage
Start treatment in 1.5 minute dosage for each treatment point and increase the dosage
gradually within 24 hours until you reach 6 min. Treat twice a day, consistently. If you
experience increased pain following treatment, stop the treatment for 24 hours then start
again with a reduced dosage. You may increase the dosage to 4 treatments a day. In
cases of acute pain, trauma or non-chronic aches, you may apply a dosage of 8 minutes
from the first treatment.
7.3 Coverage
The laser beam size is 4.5 cm long and 1 cm wide. If the area that requires treatment is
larger than the 4.5/1 cm, repeat treatments on the adjacent area until you’ve covered the
whole area.
7.4 Treatment recommendations for common conditions
The recommended time for each point of treatment is 6 minutes, 2-4 times a day.
For all recommended treatment therapies, consult the human body illustration, page 15.
1. Chronic back pain - Treat lengthwise along the painful vertebrae of the lower back,
to the left and the right of the spine. For Ischia - pain radiating to the lower limb -
Identify the focal point of the pain by touch and treat it.
2. Chronic neck pain - Treat a) Lengthwise, along the vertebra. b) Treat each side of the neck, lengthwise; under
the ear lobe, and exactly at the indentation behind the jaw.
For wound treatment
Set treatment time to 6 minutes. Activate the laser beam and hold the
device about 1 cm above the wound, motionless, until the termination
of the set treatment time. If the area of the wound exceeds the size of
the laser beam area (1
x 4.5 cm), set the stopwatch again to 6 minutes
and treat the adjacent treatment point and repeat until the whole
surface area of the wound has been covered.
In order to ease the holding of the device and improve posture, it is
recommended that the B-CURE stand should be used.
Using B-Cure Laser Pro to treat diabetic wounds and hard to heal
wounds, is in addition to the standard treatment and does not replace
it. The illustration demonstrates treating a wound that is 4 cm wide
and requires two consecutive treatments. Place the device, for 6
minutes, on one area unit, and then, set it again for 6 minutes and
treat the adjacent area unit. Make sure, to perfectly cover the margins
of the wound measuring 3 millimeter on each side.
B
-
Cure adjustable Stand
1 cm
4.5 cm
The size of the laser
beam of the
B-CURE® LASER