4
1
2
GETTING TO KNOW YOUR
MATRIX 2000 AMPLIFIER
1.
AMPLIFIER: The MATRIX 2000 amplifier panel.
2.
LEFT SPEAKER OUTPUT: Speakon-style connector output for left satellite speaker.
3.
COOLING FANS: The two fans keep the amplifier cool during operation. Ensure these
cooling fans are clear of external obstructions for efficient operation.
4.
POWER CORD CONNECTOR: For attachment of the included power cord.
5.
FUSE HOLDER: Contains primary fuse.
See warning below for important safety information.
6.
POWER ON/OFF SWITCH: Turns the MATRIX 2000 on or off. Red lights indicates ON.
7.
VOLTAGE SWITCH: Enables the MATRIX 2000 to be switch from 115 volts to 230 volts.
See warning below for important safety information.
8.
RIGHT SPEAKER OUTPUT: Speakon-style connector output for right satellite speaker.
9.
PHASE SWITCH: Sets the absolute polarity of the 18” subwoofer. Set the switch to the position
where the bass sounds the loudest. If no difference is heard, place in the ON position.
10.
SUBWOOFER GAIN CONTROL: Controls the level of the subwoofer.
11.
GROUND/LIFT SWITCH: Removes earth ground from circuit to eliminate excessive
60-cycle hum caused by ground loops.
12.
RIGHT SATELLITE GAIN CONTROL: Controls the levels of Gain to the right side satellite
speaker.
13.
RIGHT FULL-RANGE OUTPUT: Sends full range signal out to other systems.
14.
RIGHT FULL-RANGE INPUT: Connect the right channel from your signal source to this
connector (such as your mixer or CD player).
15.
LEFT SATELLITE GAIN CONTROL: Controls the levels of Gain to the left side satellite speaker.
16.
LEFT FULL-RANGE OUTPUT: Sends full range signal out to other devices.
17.
LEFT FULL-RANGE INPUT: Connect the left channel from your signal source to this
connector (such as your mixer or CD player).
18.
REINFORCEMENT SCREW: This screw connects the amplifier panel to the subwoofer
cabinet. Remove this screw in order to remove the amplifier from the subwoofer cabinet.
This should only be done by an authorized B-52 Service Center.
IMPORTANT: VOLTAGE SWITCH & FUSE HOLDER
U.S.A Customers: The MATRIX 2000 is already positioned to the correct voltage (115v) and
has in place the correct fuse. DO NOT change the position of the voltage switch or fuse value
while operating in the U.S.
International Customers: The MATRIX 2000 is shipped internationally from our U.S. factory,
with the voltage switch and fuse correctly set to your country’s requirements. DO NOT change
the position of the voltage switch or fuse value.
Содержание MATRIX 2000
Страница 1: ......
Страница 5: ...5 3 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 ...
