B-52 AT-100, Инструкция по эксплуатации

Страница: 5 / 8

1. POWER ON/OFF SWITCH: Turns the AT-100 on and off.
2. STANDBY ON/OFF SWITCH: Allows the AT-100 to remain
turned ON for limited periods of inactivity without the risk of
damaging / over-heating the amplifier tubes. When the Standby
switch is in the STANDBY position the AT-100 is in a non-
operational setting. When in Standby the Sovtek tubes remain
hot and ready for use. This bypasses the time required for the
tubes to warm up before use. When the Standby switch is in the
ON position the AT-100 is operational and should not be left
inactive. DO NOT turn on the AT-100 or have the Standby
switch set to ON without it connected to a loudspeaker.
3. PILOT JEWEL. Power on indicator.
4. MASTER REVERB CONTROL: Adjusts the amount of reverb
produced by the amplifier. To increase the amount of reverb turn
clockwise.
5. MASTER LOW RESONANCE: Controls the overall resonance
of the amplifier. Turning the control clockwise adds rich low end.
6. MASTER VOLUME: Controls the overall signal level of the
AT-100. To increase the overall signal and/or volume, rotate
the control clockwise. The Master volume control allows you to
preset the output levels of both the Clean and Overdrive
Channels.
7. CLEAN CHANNEL – VOLUME: Controls the overall signal level
of the clean channel.Adjusting the volume control enables you to
produce sparkling clean sounds to crunchy, dirty blues. Turned
all the way to the left you will experience clean sounds. A setting
all the way to the right will produce moderate levels of distortion.
8. CLEAN CHANNEL - BRIGHT: Adds high end sparkle.
9. CLEAN CHANNEL - TREBLE: Adjusts the amount of high
frequency boost or cut as desired in the clean channel. Treble
adds brightness to your tone. Turning this control clockwise will
add brilliance to your sound. Turning the control counter-
clockwise softens the tone.
10. CLEAN CHANNEL - MIDDLE: Adjusts the amount of mid-range
frequencies as desired in the clean channel. Turning the middle
control clockwise will increase the amount of warmth in your
tone. Counterclockwise settings create a more pristine, acoustic
kind of sound.
26. EFFECTS - SEND JACK: Connects to the AT-100 to the input
off an effects unit.
27. EFFECTS – SEND LEVEL: Controls the sending level output to
an effects unit.
28. EFFECTS – RETURN LEVEL: Controls the input capacity of
the returning signal from an effects unit.
29. EFFECTS – RETURN JACK: Connects the AT-100 to the
output of an effects unit.
30. FOOTSWITCH – GAIN AND CHANNEL SWITCH: Switch
between Gain 1 and Gain 2 in the overdrive Channel. Also
switches between clean and overdrive channel.
31. FOOTSWITCH - EFFECTS/REVERB: Connects footswitch to
turn the reverb on/off and the effects loop on/off.
32. LINE OUT JACK: Connects the AT-100 to an external line-
level device such as a mixing board.
33. LINE OUT LEVEL CONTROL: Controls the output capacity of
the Line Out Level.
34. IMPEDANCE SELECTOR SWITCH: Allows the AT-100 to safely
AT-100 - Rear Panel Features & Descriptions
To reduce the risk of fire or electrical shock, do not expose this unit to rain
or moisture. Do not operate your AT-100 near a pool or other standing
water. Make sure all blades on the polarized power plug are fully inserted
into the power source. Ensure the powercord is not stretched, pinched or
otherwise abused. Ensure the power cord is routed to avoid foot traffic.
Your AT-100 amplifier should be cleaned only with a dry cloth.
WARNING: SHOCK HAZARD!
4
AT-100 - FRONT PANEL FEATURES & DESCRIPTIONS