The P4 Mainboard Series
Page 13
2.3.2. Memory Modules
The
P4
mainboards have two 184-pin DDR DIMM slots and are able to support
a maximum of
1GB of DDR200/266 memory
. The DDR DIMM slots are
located on the right hand side of the board. To install the DIMM
s into these
slots, make sure the white lever at each side of the slot has been pulled down
to an angle of approximately 45
. Make sure that the DIMM is in the correct
orientation. Place the DIMM on the slot and push down firmly.The white levers
will come back up and lock the module in place.
Important: The DIMM’s can only be fitted into the slots in one orienta-
tion. Make sure that the DIMM’s are in the correct orientation and the
pins are correctly aligned before you insert them.
Hardware Installation
5. When the CPU is installed correctly push the lever back into place.
6.
Install a proper heat sink with cooling fan
for proper heat dissi-
pation. Failing to install a heat sink with cooling fan may cause over-
heating which will burnout your CPU and damage your mainboard.
IMPORTANT: CPU COOLING FAN
Please ensure that you have an approved heat sink with cooling fan.
Without a proper heat sink with cooling fan you will damage both the
mainboard and the CPU.
184-pin DIMM Slot
*"
"
DIMM 1
DIMM 2
CPU Socket 478
m
P
G
A
478
B
m
P
G
A
478
B
m
P
G
A
478
B
Supports
Pentium
TM
4
Pin 1
$%!'*4%:(' 0%63
'A6#50A6#56#*!'!23
,0!,!,%, ''
38!'' 60,' !,,
6
