AzureWave AW-CM195NF, Руководство пользователя

Страница: 21 / 27

- 21 -
3. Close the “Log Window.” If this window is left open or minimized, then the throughput test will not
achieve maximum throughput because of delay that is added by Windows every time the log window is
updated.
4. On the Slave side, click “Execute Test” in the “Receive Test” window.
5. On the Master side, click “Execute Test” in the “Transmit Test” window.
Bluetooth throughput test is now running.
To stop the test, click “Abort Test” on the Master side first, then on the slave side.
RF Performance Test
The following procedure explains how to configure the AW-CM195NF for RF testing using Broadcom
BlueTool. At the completion
of the procedure, connect the Bluetooth test instrument to the AW-CM195NF with RF cable and performs the
RF tests.
RESETTING THE USB DEVICE
To reset the USB device
•In HCI Control, in the HCI Control commands list, select 7.3: Host Controller & Baseband Commands (3
key), and then double-click Reset.
READING THE BLUETOOTH DEVICE ADDRESS
To read the Bluetooth Device Address
• In HCI Control, in the HCI Control commands list, select 7.4: Informational Parameters (4 key), and then
double-click
Read_BD_ADDR.
The Bluetooth Device Address (BD_ADDR) is displayed in the log window. The Bluetooth Device Address
might be needed
by the Bluetooth tester
SETTING THE EVENT FILTER TO AUTOMATICALLY ALLOW CONNECTION
To set the event filter to automatically allow connection
1. In HCI Control, in the HCI Control commands list, select 7.3: Host Controller & Baseband Commands (3
key), and