SERVICE
VALVE SERVICE:
•
Adjustment — Turning the adjusting nut on the valve
control lever located on the handle and locking with
the jam nut will determine how much solution is
dispensed on the floor. Normal operation will require
about 1/8" of play in the valve control lever.
•
Re-Seating Valve — Remove cable from valve
control lever. Hold back conduit in one hand and
the cable in the other. Pull the cable out as far as
possible and let “SNAP” back. Repeat three times.
•
Debris in Valve — Squeeze a valve control lever and
force water with a hose through that valve port inside
the tank.
MANIFOLD SERVICE:
•
Cleaning Manifold — Remove both end caps and
clean out with hose. Replace end caps.
REPAIRING LEAKS:
1)
Isolate leak.
•
Fitting Leak — Remove fitting, clean and smooth the
surface and/or gasket. Apply silicon and re-install.
•
Body Leak — Contact Aztec.
LIQUIDATOR PG. 3
1.
314-J208PA-L7/8 – Valve Control Lever
2.
285-74-9051 – Handle
3.
164-931CNKLSZ -5/16-18 – Kep Nut
4.
647-60032 – 8" Lid and Ring
5.
216-PVC-3/4 – Wheel Spacer
6A. 173-MC091P10 – Pivot Bolt Spring
6B. 173-MXQ11509MW – Arm Spring
7.
196-71200 – Nylon Bushing
8.
012-52-5211R – Right Manifold Assembly
9.
156-PB-03041-08 – Guide Wheels
10. 175-03125N – Spreader Rubber
11. 166-3EL1234G – Manifold Fitting
12. 012-52-5210F – Front Manifold Assembly
13. 150-I7101 – 1 1/2 Gate Valve
14. 156-2-4056-445 – 4" Swivel Caster
15. 166-3F126 – 1/2 MPT End Plug
16. 216-0751 – 3/4 Poly Tubing
17. 175-03125N – Spreader Rubber
18. 164-76-100Z-W2 – Axle Spacer Washer
19. 156-XA-08251-12 – 8" Wheel
20. 012-52-5270 – Valve Assembly
21. 012-962C – Valve Cable
21
20
19
18
15
17
14
13
12
11
10
9
8
7
6
16
5
4
3
2
1
(Not Shown)
(Not Shown)
