802.11g Wireless USB Adapter
19
Check that the Network Connection for the wireless client is configured
properly.
If Security is enabled, make sure that the correct encryption keys are
entered on both the AWU354 and the access point.
4. I can’t find any wireless access point / wireless device in Network tab.
Click Rescan for few more times and see if you can find any wireless access
point or wireless device.
Try moving closer to any known wireless access points.
Ad-hoc function must be enabled for the wireless device you wish to
establish a direct wireless link.
Please adjust the position of the AWU354 (you may have to move your
computer if you’re using a notebook computer) and click Rescan button for
few more times. If you can find other wireless access point or wireless
devices but not yours, please contact the manufacturer of your wireless
router/AP for support.
5. Nothing happens when I click Launch config utilities
Please make sure the AWU354 is inserted into your computer’s USB port. If
the Ralink configuration utility’s icon has an “X”, the AWU354 is not
detected by your computer.
Reboot the computer and try again.
Remove the AWU354 and insert it into another USB port.
Remove the driver and re-install.
6. I can not establish connection with a certain wireless access point
Try clicking Connect a few more times.
If the SSID of the access point you wish to connect is hidden (nothing
displayed in SSID field in Network tab), you will have to input the correct
SSID of the access point you wish to connect manually.
Please double check the passphrase / security key of the access point with
security encryption.
The access point you wish to connect might only allow network cards with
specific MAC addresses to establish connection. Please go to About tab and
write the value of Phy_Addess down, then present this value to the owner
of access point to add the MAC address of your AWU354 to owner’s access
point’s list.
7. The network is slow or having problem transferring large files
Try moving closer to the place where access point is located.
Try a lower TX Rate in Advanced tab.
Disable Tx Burst in Advanced tab.
Enable WMM in WMM tab if you need to use multimedia / telephony related
applications.
Disable WMM – Power Save Enable in WMM tab.
There could be too much people using the same radio channel. Try
changing the channel of the access point.
