5.2.4 SEMIAUTOMATIC OPERATING CYCLE
F01=03 SEMIAUTOMATIC OPERATING CYCLE
After setting the semiautomatic cycle . Press START(A) Press buttons
(F)
and
(G)
to wrap
the pallet. To stop the machine, press the previously pressed button once again.
5.3 LOADING A ROLL OF FILM
This is a general procedure (see fig. 5.6).
Carriage-specific operations are described in the relative roll-holder carriage manual.
a) Lower the roll-holder carriage
(1)
to make it easier to load the roll;
b) turn the main switch
(2)
to
'O' - OFF
;
c) open the carriage door (depending on the carriage model);
d) push the roll
(3)
onto the carriage pin
(4)
;
e) unwrap the film and thread it between the rollers;
f) close the carriage door.
5.4 STARTING THE MACHINE
a) Correctly place the pallet on the turntable
(5)
(Fig. 5.6);
b) check that there is a roll of film
(3)
on the roll-holder shaft
(4)
and check that the film is
correctly routed according to the diagram (see plate
(6)
indicated for the carriage
(1)
being used;
c) turn
ON
the panel using the main switch
(1)
and press the reset button
(2)
to enable the
machine;
d) manually draw out the film protruding from the roll-holder carriage
(1)
and attach it to a
corner of the pallet;
e) set the operating cycle from the control panel as described in points 5.2 and 5.3;
f) press the START button
(A)
;
g) After wrapping, manually cut the film and fix it to the pallet;
h) the pallet can now be unloaded.
38
Packaging Equipment
DO NOT
LEAVE
THE
PALLET
WITH LOAD
ON
T
HE TURNTABLE
AFTER
WORK.
CONTINUOUS STATIC
LOAD
ON THE
TABLE
CAN CAUSE
DESTRUCTION OF ROLLER
B
EARING
.
