6
INSTALLATION GUIDE
Installation
SmartMirror™
1. Install universal windshield mount to
SmartMirror using supplied screws. There
are mul
ti
ple holes to allow proper mirror
placement. Do not over
ti
ghten screws.
2. Mount Smart Mirror to windshield
by sliding universal mount over factory bu
tt
on on wind-
shield. Tighten screw using supplied allen key.
3. Find suitable moun
ti
ng loca
ti
on for microphone. For best results
place microphone within two (2) feet of the drivers' head. The top
of the A-pillar or above mirror in center of windshield are recom
mended loca
ti
ons. Route wire to mirror and plug into 1/8” jack.
4. Plug in supplied power harness and route to suitable loca
ti
on to
make power connec
ti
ons. Connect wires to car as follows:
Yellow
12-Volt Constant
Red
12-Volt Switched (Igni
ti
on)
Black
Chassis Ground
Green
Reverse Light
Video 1 RCA
Addi
ti
onal Camera
Video 2 RCA
Reverse Camera Input
3
Introduction
INSTALLATION GUIDE
SmartMirror™
Parts Included:
- SmartMirror
- Wire harness
- Universal mount & screws
- Universal bu
tt
on
- Allen key
- External GPS antenna (not used with all installa
ti
ons)
Tools Recommended for Proper Installa
ti
on:
- Safety Glasses
- DC voltmeter or test light
- Crimping pliers
- Wire strippers
Prepara
ti
on
- Inspect mirror for damage
- Check parts list for accuracy.
Note: Azentek does not recommend installing this mirror if your
vehicle has airbag sensors in the headliner area or if your vehicle is
equipped with OnStar.
If your car, truck or suv mirror is mounted within the windshield, not
stuck on like the wedge mount or camlock style, detachment is not
recommended. If your windshield wipers have a sensor mounted to
your rearview mirror, installa
ti
on of this mirror will inac
ti
vate that
func
ti
on.
