Page 8
Dia. #1
Dia. #2
Dia. #2
Secure Level Balustrades to Posts
Slide bottom channel of pre-cut balustrade on
to lower clip.
(Dia. #2)
Tip:
to avoid scratching
the posts, slide balustrade in from the side, then
downward onto the brackets.
• Insert clips into top channel of balustrade on
each end.
• Using (4) - #8x20mm self-drilling screws, attach
the upper two clips to the post.
• Using (8) - #8x20mm self-drilling screws,
secure the upper and lower clips to the
balustrade.
• Tip:
Use a 150mm drill bit for easier installation
of top attachment clip to post.
Cut Level Balustrades
Clamp or hold balustrade against post,
adjust for equal end spacing.
(Dia. #1)
• Determine the desired center of the
balustrade; either a baluster hole or
between two baluster holes.
(Dia. #2)
• Measuring from the determined
center, cut both ends of the
balustrades.
• Mark the hand and base rails
• Cut balustrade 2mm less than
opening size.
• Clean cut areas and apply touch-up
paint on exposed ends. Touch-up
paint sold separately.
2
1
Installing Level Balustrades
Centerline
Even number of balusters
Install Self-drilling Screws,
2x #8 x 20mm Outside,
2x #8 x 20mm Inside
Temporarily clamp balustrade against posts,
mark for cutting.
Cut balustrade 2mm less than opening size
Post
Assembly
Assembled
Balustrade
Balustrade
Clip
Install
balustrade
on lower clip
Slide hand rail clip
into channel & slide
against post
Balustrade
Clip
