WM-PRO TRANSMITTER SET-UP :
(1)
LOADING THE BATTERY :
(see diagram)
Insert One (1) 9 volt battery into the Transmitter
BEING CAREFUL NOT TO FORCE THE BATTERY
COMPARTMENT CLOSED.
If it doesn’t close easily, take the battery out and turn it around.
(2)
MICROPHONE :
Plug the EX-503 (lapel mic) into the mic jack. Extend the cord as much as possible, since it doubles as the
transmitter’s antenna.
(3)
POWER/FREQUENCY SWITCH :
This slide switch is used to turn the system on and off and to select a frequency. Turn on the WM-PRO to F1, the
LED will light up indicating that the battery is good and the Transmitter is functioning properly. If you find
reception to be noisy on F1, change position of switch to F2. Make sure that the Receiver is on the same
frequency as the Transmitter.
(4)
MOUNTING :
The transmitter can be attached to a belt using the clip provided or placed in a pocket.
NOTES :
●
Do not store or use the unit in high heat or humidity.
●
Do not use near a broadcast station, airport or plane and
you must change frequencies if you are interfering with
other transmissions.
●
The system will work continuously for 10 hours on one set of batteries. If sound quality is poor, change batteries.
●
Remove batteries when not using the system.
SPESIFICATIONS :
TRANSMITTER
Transmission frequency :
Modulation system :
Modulation sensitivity :
Battery :
Power consumption :
Dimensions :
Weight :
Microphone :
F1 ; 187.550MHz
F2 ; 187.900MHz
FM modulation
94dB SPL at
±
2.5kHz Dev
One 9V (not included)
30mA
86(h)
×
60(w)
×
21.5(d) mm
98g (including battery)
Electret condenser
EX-503
RECEIVER
Reception frequency :
Reception sensitivity :
Battery :
Power consumption :
Monitor output :
Microphone output :
Dimensions :
Weight :
Supplied accessories :
F1 ; 187.550MHz
F2 ; 187.900MHz
Double superheterodyne system
2
μ
V at S/N 40dB
One 9V (not included)
25mA
Voltage ; 1V
(Load ; 30ohms,Modfreq ;
1kHz,Dev ;
±
7kHz)
Voltage ; 8mV
(Load ; 10k ohms, Modfreq;
1kHz, Dev ;
±
7kHz)
Impedance ; 300 ohms
86(h)
×
60(w)
×
21.5(d)mm
128g (including battery)
Earphone (1)
Design and specifications subject to change without notice.
1-12-17,KAMIRENJAKU, MITAKA,TOKYO, 181-8533 JAPAN
PRINTED IN JAPAN
060-35046-01
