Azden PRO-XR, Инструкция по эксплуатации

Страница: 8 / 12

Connecting to a Mobile Device with TRRS Headphone Jack
(Most Android devices / older iOS devices)
1. Connect the male end of the TRS to TRRS Adapter Cable to the headphone jack of your device.
2. Connect one end of the Audio Output Cable to the female end of the TRS to TRRS Adapter Cable.
3. Connect the remaining end of the Audio Output Cable to the PRO-XR receiver’s MIC OUT jack (located on
the side of the unit).
Audio Output Cable
TRS to TRRS
Adapter
Connect to RX “MIC OUT”
to heaphone
jack
Android Device
Use With a Computer
TRRS Jack / Headset Inputs : Many computers today are equipped with the same type of headphone jack as
found in mobile devices. This type of headphone jack incorporates the microphone input with the headphone
output. This is sometimes referred to as a headset input or TRRS jack. If your computer has this type of jack you
can connect the PRO-XR receiver in the same way as stated above in “Connecting to a Mobile Device with TRRS
Headphone Jack.”
Dedicated Microphone Inputs: Some computers are equipped with a dedicated 3.5 mm stereo microphone
input. To properly identify this input, consult your computer’s manual. If your computer has this input, then you
may connect the PRO-XR receiver in the same way you would a camera with a 3.5 mm microphone input, without
the use of any adapters.
Be aware that with a computer you may need to change the audio settings in the operating system and/or in the
software you are using in order to utilize the audio coming from the PRO-XR system.
Use With Other Types Of Audio Equipment
The microphone output of the PRO-XR receiver is an analog, microphone level audio signal and thus can be used
with any other analog microphone inputs so long as the correct cable is used. For 3.5 mm microphone inputs, the
included Audio Output Cable will work. For balanced, XLR microphone inputs, it is required that you use the
Azden MX-2 Mini to XLR Stereo Y Cable (sold separately). While the MX-2 provides 2 male XLR connectors, it is
only necessary to connect 1 to your equipment (does not matter which).
Be advised that the PRO-XR receiver’s MIC OUT is not compatible with line level inputs, such as inputs labeled
as AUX or auxiliary.
Using the Smartphone Mount
The PRO-XR package includes Azden’s Smartphone Mount. To
attach it to a smartphone: With the smartphone’s back facing the
inside of the mount, insert the bottom edge of the device into the
mount’s curved lip (at the bottom). As you angle your device so that
its back sits flush against the mount, pull to extend the mount so that
it clamps down snugly to the top edge.
The Smartphone Mount can accommodate phone widths from 2.4 –
3.3 inches, which should be wide enough for most phones even while
inside of a case. Use the cold-shoe slot on top to attach the PRO-XR
receiver or other shoe-mount accessories. The ¼”-20 threaded hole
on the bottom will allow you to attach the mount to a tripod or mobile
grip.
mount receiver
optionally
attach to tripod
8