(19)Memory Mode Indicator (M Mode): This indicator lights up when the PCS—6000 is in the
memory mode. In this mode, the up/down keys function as memory address keys, and the
scan key as memory scan key. When the indicator is not lit, the unit is in the up/down
mode.
(20)Function Indicator (F): This indicator will light up when the ‘F’ key (function key) is
depressed, allowing each key to operate as indicated on each keytop.
(21)Control Microphone Connector: This is used to connect the control microphone supplied
with the unit. For details of the microphone, refer to page 13
— How To Use Keyboard —
1. Setting Frequencies: Before attempting to set frequencies, check to see whether or not the
unit is in the memory mode (M MODE lit or not). If M MODE is lit, press the M MODE
key once to release the memory mode and return to up/down mode. You can set or change
frequencies by the UP and or DOWN keys.
When the UP key is pushed once, the operating frequency is moved up by
5kHz, and when the DOWN key is pressed, the frequency is moved down by
5kHz. Channel frequency step is variable to 10kHz, 15kHz and or 20kHz by
following the program procedure given at page 9
2. Rapid Channel Change.. .(UP, DOWN): The frequency is automatically changed up or
down by holding down the UP or the DOWN key for more than about a second. As the
desired frequency is approached, release the key and then push the UP or DOWN key
repeatedly until the desired frequency is obtained.
3. MHz unit Change: When the function key ‘F’ is pressed and Function Indicator F(2O) is
indicated, pressing either the UP key or DOWN key once will move up or down the
operating frequency by 1MHz.
Note:
1) The ‘F’ indicator is released by any of the key operation other than MHz
Frequency Change and Shift Direction Change procedures.
2) The ‘F’ indicator is automatically released in about 3 seconds unless other key is
pressed after the ‘F’ is pushed.
3) The ‘F’ indicator is released by pressing the ‘F’ key.
4. Transmit Output Change: Press the ‘F’ key to light up the “F” indicator.
Then press the ‘H/L’ key to select the high power output 25W/45W(PCS—6000/
PCS—6000H) and or the low power output 5W/lOW (6000/6000H). The Low Power
Indicator (9) comes on when the transmit output is set at low power.
—6—