Azden 330UPR, Инструкция по эксплуатации

Страница: 7 / 12

27. LCD Display
Multifunctional display shows battery life, audio level and frequency selection. Refer to “LCD Display
Readouts” in this manual for further details.
28. Battery Compartment Cover
Remove the battery compartment cover by twisting it counterclockwise and sliding it down.
29. Battery Compartment
Install two fresh alkaline “AA” batteries. Make sure the battery polarity is correct as marked inside the
battery compartment.
30. MIC LEVEL control
This enables you to adjust the audio level of the microphone. Using the supplied tool, turn the dial
clockwise to increase, or counterclockwise to decrease the audio level.
31. Channel UP/DOWN buttons
Press the UP and DOWN buttons to change the transmission frequency. Group/Frequency numbers
are shown on the LCD.
32. POWER Switch
Located on the bottom of the unit, this switch turns the 35HT Transmitter/Microphone “ON” or “OFF”.
35HT Handheld Microphone/Transmitter
23. Phantom Power Switch
Flip this switch to “48V” to turn on phantom power. Use only for microphones that require phantom
power.
24. LCD Display
Multifunctional display shows battery life, audio level and frequency selection. Refer to “LCD Display
Readouts” in this manual for further details.
25. CHANNEL UP/DOWN Buttons
Press the UP and DOWN buttons to change the transmission frequency. Group/Frequency numbers
are shown on the LCD.
26. MIC Connector/Locking Ring
This 3-pin female XLR connector is the microphone input. Any low impedance microphone with a
corresponding male connector may be plugged here. Once the microphone is plugged into the 35XT,
the locking ring should be rotated clockwise until snug. To remove the microphone, first rotate the
locking ring counterclockwise and then pull the microphone away while pressing the XLR release.
27
32
29
31
28
30
7
19. Battery Compartment
Open the battery compartment lid by pushing down on the tab and lifting it up. Install two fresh
alkaline “AA” batteries. Make sure the battery polarity is correct as marked inside the battery
compartment.
20. POWER Switch
Turns the 35XT Transmitter “ON” or “OFF”.
21. AUDIO Switch
It is best to set the AUDIO switch to “STBY” prior to first turning the POWER switch “ON”. When you
are ready to begin transmitting, turn the AUDIO switch ON. The STBY position acts as a mute
function that maintains the RF signal but turns off the audio.
22. MIC Input LEVEL Control
This enables you to adjust the input level of the connected microphone. Using the supplied tool, turn
the dial clockwise to increase, or counterclockwise to decrease the input level.