4
1
Thank you for purchasing Azden’s 200UPR or 200ULT/ULH/ULX wireless system,
which consists of the 200UPR receiver, 10BT transmitter and EX-503 lapel
microphone, the 10HT transmitter or the 51XT Plug-in transmitter. This equipment
is designed primarily for video cameras but is usable with most electronic
components having a microphone level input. The 200UPR allows you to “receive”
audio from two different transmitters simultaneously.
RECEIVER (200UPR)
(1-2) Power:
Remove the battery compartment lid (1) and insert six fresh Alkaline “AA” batteries
into the compartment. Make sure the battery polarity is correct as marked inside
the battery compartment. The receiver can also be powered by an external 12VDC
supply that provides 200mA (2). Follow the markings on the receiver for proper
polarity.
(3-4) Frequency select (one “set” for each channel):
With the frequency group dial on the left (3) you can select any of seven frequency
groups (numbered from 0-6). With the frequency channel dial on the right (4) you
can select any of nine frequency channels (numbered 0-8).
(5) Power (one switch for each channel)
Switches the receiver “On” or “Off”.
(6) Mic Out jack
The 200UPR is supplied with both a mini-to-mini (3-conductor-to-3-conductor)
cable and a mini-to-dual XLR cable. Which cable you use depends on the input
connector(s) on your camera.
(7) LED indicator (one for each channel)
The LED turns
red
when the receiver is switched “On” and
green
when receiving
a signal from the transmitter.
(8) Antennas
Attach both BNC connector antennas by pressing down and rotating clockwise.
The antennas can be adjusted so that they are vertical when in use.
200UPR Receiver
Mount the receiver to your camera using either the supplied hot-shoe mount (9).
Connect the appropriate output cable to the receiver and to the microphone
input(s) on your video camera. Switch one or both channels of the 200UPR to
“ON” and the LED(s) should turn
red
. If either does not light, check the battery.
When the 200UPR receives a signal the LED for that channel will turn
green
.
10BT Bodypack Transmitter
Plug in the supplied lapel microphone and clip it to your subject. The microphone
should be placed 4-12 inches from your subject’s mouth. Clip the transmitter to
a belt using the supplied belt-clip (15) or place it in a pocket. Switch the transmitter
Power and Audio to “ON”. The LED should light
green
. If it does not, check the
battery. Have someone speak into the microphone as you monitor the sound
through thecamera’s monitor output. If the sound is distorted lower the input gain
on the transmitter. If there is not enough volume raise the input gain on the
transmitter.
10HT Handheld Transmitter
Switch the transmitter to “ON”. The LED should light
green
. If it does not, check
the batteries. If it glows
red
it is time to replace the batteries. Have someone
speak into the microphone as you monitor the sound through the camera’s monitor
output. If the sound is distorted lower the gain on the transmitter. If there is not
enough volume raise the gain on the transmitter.
51XT Plug-In Transmitter
Switch the transmitter to “ON”. The LED should light
green
. If it does not, check
the battery. Have someone speak into the microphone as you monitor the sound
through the camera’s monitor output. If the sound is distorted lower the gain on
the transmitter. If there is not enough volume raise the gain on the transmitter.
