THE 1000BT TRANSMITTER
1
7
8
9
10
♣
♠
THE 1000URX\AB and 10000URX\VM
The 1000URX\AB is a specially developed version that integrates the Anton/Bauer “Gold Mount” to
power the receiver. The 1000URX\VM is a specially developed version that integrates the IDX
battery-mount to power the receiver. All of the functions and controls on the 1000URX remain
unchanged except for the method of powering the receiver. Instead of the 4-pin XLR connector, the
1000URX\AB attaches between the camera and Anton Bauer battery pack using the “Gold Mount”
system while the 1000URX\VM attaches between the camera and an IDX “V-Mount” battery pack.
THE 1000URX\Si
The 1000URX\Si receiver is specially designed to work with specific Panasonic “Slot-In” and
Ikegami “Uni-Slot” cameras. Once mounted in the camera, the DB-25 connector on the bottom
provides the receiver with power directly from the camera’s power supply (battery) while delivering
audio directly to the camera’s audio input. Items
A.
and
C.
on page 2 and
C.
on page 3 apply directly
to the 1000URX\Si.
1000URX\Si Top panel display and operation
1)PWR ON Switch
Turn the switch to ON to power up the receiver.
The display will show the same channel number as when the receiver was
last turned off. (Last channel memory feature)
2) MODE Switch - Pushing the switch can perform three different functions.
Mode-1:Displays the Channel Number, RF level, AF level and Diversity (A or B). By pressing the
mode switch for one second, the receiving frequency will be displayed shortly and then return to the
channel number display.
Mode-2:To change the channel, press the mode switch. “CH” will blink in the display, push the UP
or DOWN buttons to find the desired channel. The channel number starts at CH000 to CH120 (total
of 121 channels). When the receiver is turned OFF the last channel chosen will be stored in memory.
Mode-3:To change the squelch level, press the mode switch again. SQ-0 will show in the display.
In SQ-0 the squelch function is:
SQ-0 (on on) : RF mute-ON, Tone mute-ON (factory setting)
Push the UP or DOWN buttons to change squelch setting to SQ-1 or SQ-2
In SQ-1 the squelch function is:
SQ-1 (on oFF) RF mute-On, Tone mute-OFF
4
5
Powering the 1000BT Transmitter
The 1000BT uses a single Alkaline 9V battery for power. The battery is
placed in the battery compartment by sliding the battery compartment
door [
k
] down and placing the battery in the compartment as shown
in the illustration [
♠
]. The compartment is designed to allow the bat-
tery to be inserted only one way - with the correct polarity.
DO NOT
FORCE THE BATTERY INTO THE COMPARTMENT.
Azden does not
recommend the use of rechargeable batteries.
In SQ-2 the squelch function is:
SQ-2 (oFF oFF) RF mute-OFF, Tone mute-OFF.
When the receiver is turned OFF it will reset to SQ-0
3) UP/DOWN SWITCH
When the receiver is in Mode-1 the UP/DOWN switch will not function. When the receiver is in
Mode-2 use the UP/DOWN switch to change the channel number. Hold down the switch to change
quickly through the channel numbers. When the receiver is in Mode-3 use the UP/DOWN switch to
change the 0squelch setting to SQ-0, SQ-1 or SQ-2.
1000URX\Si Top panel display and operation (continued)
2
4
5
6
3
