AZ Patio Heaters F-1350-FPT, Руководство пользователя

Страница: 13 / 17

13
OPERATION INSTRUCTIONS
DANGER
• CARBON MONOXIDE HAZARD
• For outdoor use only. Never use inside house, or other
unventilated or enclosed areas. This fire pit consumes air
(oxygen). Do not use in unventilated or enclosed areas to
avoid endangering your life.
Very hot while in operation!
Never lean over the fireplace while in use.
Failure to comply with these instructions may result in
serious bodily injury.
WARNING
Before Turning Gas Supply ON:
1. Your fire pit was designed and approved for outdoor use only. Do NOT use it inside a building,
garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable
vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and
there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly
or servicing is replaced and fastened prior to starting.
Before Lighting:
1. Fire pit should be thoroughly inspected before each use, and by a qualified service person at least
annually. If relighting a hot fire pit, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas
should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the
replacement hose assembly specified by manufacturer. The burner must be replaced prior to the
appliance being put into operation if it is evident that the burner is damaged. The replacement burner
should be specified by manufacturer.
Lighting:
1) Turn the control knob to the “OFF” position (Figure a).
2) Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for
2 minutes to purge air from gas lines before proceeding.
3) Push in gas control knob and turn counterclockwise to “IGNITE”
(Figure b) to light the fire pit. If needed, keep depressing and turning control knob
counterclockwise until the heater lights (You should hear a clicking sound).
4) After fire pit lights, release control knob. Push in and turn the control knob to the “HIGH”, then
release control knob. If you want a lower temperature, push in the control knob and turn
counterclockwise to the “LOW” (Figure c).
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least 5
minutes should pass before attempting to light.
Caution:Do not attempt to operate until you have read and understand all General Safety Information
in this manual and all assembly is complete and leak checks have been performed.
Figure a
OFF
P
us
h
to
tu
H
r
G
n
I
H
LOW
E
T
I
N
G
I
Figure b
OFF
P
us
h
to
tu
H
r
G
n
I
H
LO
W
E
T
I
N
G
I
Figure c
OFF
P
us
h
to
tu
H
r
G
n
I
H
LOW
E
T
I
N
G
I
in.
in.
in.
in.
in.
in.
Normal Abnormal