NOTE:
The joystick can be reassigned to an output on another DMX channel. Press Auto/Del and Mode
buttons at the same time to delete the assignment
NOTE:
You can re-assign the DMX channel to all controller fader channels
Change joystick assignment
To re-assign the joystick (for example, if you wish to control other functions and/or fixtures), follow the same
steps used to assign the joystick to certain channels.
Assignment reverse
- Press and hold the Fine & Mode buttons together once to access the joystick assignment mode.
- Press a scanner to select the fixture of your choice
- Press and hold Fine & Mode buttons once to exit the assignment mode.
Copy scanner
It is possible to copy the programming values of one scanner to another scanner. This way, it makes it easier
to create synchronized lightshows, without having to add the separate values each time.
- Press and hold Scanner button 1
- Press Scanner button 2
- Release Scanner button 1
- Release scanner button 2
- All Scanner LED indicators will flash, indicating that the copy was successful.
Reverse channel output
It is possible to reverse certain channel values. This way, you are able to invert certain pan and tilt values,
without having to invert the values manually.
- Press and hold the Program button until the LED blinks
- Press and hold Fine & Mode buttons together to access the channel assignment mode
- Press the scanner button of which you wish to invert a channel
- Use the Bank Up/Down buttons to select pan and tilt
- Press the Tap/Display button to switch pages, if needed
- Press and hold the Mode button, then press the corresponding Scene button to select the DMX channel of
which you wish to invert the channel
- Press and hold the Fine & Mode buttons 2 times to exit
Fade time assign
It is possible that you want to change the Fade Time behavior of the controller. This way, you are able to only
affect the pan and tilt channels of your fixtures, instead of all channels. This way, color changes, gobo
changes and macro’s will move very fast and direct, while your movements will go smoother.
- Turn off the controller
- Hold the Mode and Tap Display buttons simultaneously
- Turn on the controller
- Press the Tap Display button to toggle between two modes (ALL CH / ONLY X/Y)
- Press Mode and Tap Display buttons to save the settings. All LEDs will blink to confirm the change.
NOTE:
This option only works properly when all X and Y channels are added to the joystick for each fixture.
Manual operation
The manual mode provides direct access to all scanners. This way, you are able to move and change
attributes by using the channel faders and/or joystick.
- Press the Auto Del button repeatedly until the Manual LED is lit
- Select a Scanner button
- Move faders and/or joystick as you wish
- Select Page A (1-8) or Page B (9-16) to change values for all channels in a fixture
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 3.0
Creation date + author initials: 14-01-2014 RV Revision date + author initials: 18-11-2014 RV
