Operation and Mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
The device cannot be operated while it is still starting up and the Menu screen displays ‘rST’. Once the
device has fully started up, it will automatically jump to the last mode and setting. Operation modes and other
settings shown on the display can now be adjusted or changed via the menu buttons.
If a DMX signal is detected, the device shall automatically switch to DMX mode and the DMX address that
was last used. For a new device, this is usually DMX address 001. The DMX address can of course be
changed via the display and menu buttons.
The functions, modes and settings can be changed by using the display and menu buttons. Push ‘Enter’ to
select a function or to confirm a change. Push ‘Up’ and ‘Down’ to change any values and push the ‘Menu’
button to return to the main menu. A few seconds after confirming a setting by pressing ‘Enter’, the device
shall automatically return to the main menu and perform the set actions. This can be sped up by holding the
‘Menu’ button down for 2 seconds after confirming a setting by pressing ‘Enter’. This is usually done after
adjusting the working mode or DMX address.
The Menu includes the following options and fuctions:
Display
Mode
Function
ADDR / A001
DMX Address Configuration
Address A001 … A512
CHND
Channel Mode Selection
10CH
SLND
Slave Mode
Master
Slave
SHND
Select Built-in Shows
Show mode AU0-8
SOUND
Sound-Controlled Mode
Mode: ON / OFF
SENS
Sound Sensitivity
0 - 100: Sensitivity in %
DNST
DMX Signal Loss Mode Selection
NAST - Master-modus
LAST – Last signal received
BLND – Blackout mode
LED
LED Display Off / On when not in
use
ON/OFF
DISP
Display Inversion
Display Invert, disp - dslp
REST
Reset Function
Restart the device
TEMP
Temperature Display
Displayed in Degrees Celsius
F HS
Duration of use
0000 – 9999 Hours of use
VER
Firmware Version
Displays current version of firmware installed.
This cannot be adjusted or changed
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Revision date and author's initials: -
