Operation and Mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
The device cannot be operated while it is still starting up and displays the ‘AYRA’ logo. Once the device has
fully started up, it will automatically jump to the last mode and setting. Operation modes and other settings
shown on the display can now be adjusted or changed via the menu buttons.
If a DMX signal is detected, the device shall automatically switch to DMX mode and the DMX address that
was last used. For a new device, this is usually DMX address 001. The DMX address can of course be
changed via the display and menu buttons.
The functions, modes and settings can be changed by using the display and menu buttons. Push ‘Enter’ to
select a function or to confirm a change. Push ‘Up’ and ‘Down’ to change any values and push the ‘Menu’
button to return to the main menu. A few seconds after confirming a setting by pressing ‘Enter’, the device
shall automatically return to the main menu and perform the set actions. This can be sped up by holding the
‘Menu’ button down for 2 seconds after confirming a setting by pressing ‘Enter’. This is usually done after
adjusting the working mode or DMX address.
The Menu includes the following options and fuctions:
Display
Mode
Function
ADDR / A001
DMX Address Configuration
Address A001 … A509
CHND
Channel Mode Selection
4CH / 17CH
MASL
Slave Mode
Master
Slave
LED
Show Mode Light Effect
Show 0 – 16 / OFF
Speed 1 - 8
SMD
Show mode SMD LED Ring
Show 0 – 16 / OFF
Speed 1- 8
SOUND
Sound-Controlled Mode
Mode: ON / OFF
SENS
Sensitivity
0 - 100: Sensitivity in %
DISP
LCD
INVT
LCD On / Off (display on or off when not in use)
Display Invert Yes / No
TEST
Test Mode
Test programme to check the operation of each
LED by illuminating each LED one by one
VER
Firmware Version
Displays firmware version. Cannot be adjusted
or changed.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Revision date and author's initials: -
