Operation and mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During calibration, ‘AYRA’ will be shown on the display, which means the device is not ready to be operated.
Once the device has fully started up, it will jump to the last-used mode. Operation modes and other settings
shown on the display can now be adjusted or changed by means of the menu buttons.
During startup the moving head may vibrate as it resets the pan and tilt settings. This should take no longer
than one minute.
Should the device detect a DMX signal, it will automatically switch to DMX mode and will display the last-
used address. For new devices, this will normally be DMX address 001. Of course, you can change the DMX
address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press
'Enter' to confirm an adjustment or select a function, use ‘Up’ and ‘Down’ to change amounts and ‘Menu’ to
go back to the menu. By holding the ‘Menu’ button down for 2 seconds after saving a specific setting, the
device will return to operation mode and adopt the setting. This will also be done after any changes in the
operation mode or DMX address. This operation is not always necessary, considering the device
automatically does this after a new setting is confirmed.
The menu contains the following options and functions
display
Mode
Function
ADDR
DMX address configuration
Address A001 … A512
CHND
Channel mode selection
11CH/15CH
SLND
Slave mode
Master - NAST
Slave 1 – SL 1 (Synchronise)
Slave 2 – SL 2 (Mirrored)
SHND
Show mode (for sound-activated
operation)
SH 1 – Show program 1
SH 2 – Show program 2
SH 3 – Show program 3
SH 4 – Show program 4
AUTO
Automatic mode (speed user-
adjustable)
AUT1 – Auto program 1
AUT2 – Auto program 2
AUT3 – Auto program 3
AUT4 – Auto program 4
(Adjust the speed per program by holding down
the 'Enter' button and using the Up/Down keys to
select a speed between 1 and 9. 1=slow, 9=fast)
SOUN
Sound-controlled mode (activates
built-in microphone)
Mode: ON / OFF
SENS
Sound sensitivity
000 – 100: Sensitivity in %
LED
LED Display on/off when not in
use
ON/OFF
DISP
Display inversion
Invert display, Idsp-dspI
PAN
Invert Pan (mirror)
NO – do not invert pan
YES – invert pan
TILT
Invert tilt (mirror)
NO – do not invert tilt
YES – invert tilt
TEST
Test mode
This mode tests all the functions displayed to
make sure they are functioning properly.
HOUR
Time registration
0000 – 9999 usage in hours
VER
Firmware version number
Display of firmware version number (can not be
updated by user)
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials:23-02-2017 RV
Revision date and author's initials: -