temperature is higher than 30°C, Large ice cube sizes are recommended.
Note: For the first three cycles, the ice may be small and irregular in size.
Note: When the ice collecting tray is full please remove the ice immediately, Do not allow
the ice collecting tray to overfill.
Cleaning & Use Guidance
1.
Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator
frequently. When cleaning,unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and the outside surface of the Ice
maker. Do not spray Ice maker with chemicals or diluted agents such as acids,
gasoline or oil. Rinse thoroughly before starting.
2.
Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
3.
Reuse the machine after being idled for a period of time, it may not have enough
water to pump for air retard, and the indicator of “ADD WATER” will keep lighting. At
this time, you just need to press POWER button again, the machine can enter normal
state.
4.
To ensure the cleanness of ice, please change water for water reservoir at least once
one day. If do not use for a long time, please drain the water out and clean it up.
5.
If the compressor takes a strike action for shortage water, fully water or interruption
of power supply, it will delay for 3mins to start up after restarted.
6.
Always use fresh water before starting ice production either at initial installation or
after a long shut-off period.
Troubleshooting
1.
Please note, if a power failure occurs due to disconnection of the power cord, or the
power button has been pushed off during an ice making cycle, small ice chips may
formed and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips
Содержание 7613164553461
Страница 51: ...54 55 GB...
Страница 52: ......
