2
CONNECTIONS
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
Note:
If installing an ASWC-1 (sold separately), there will be an accessory wire on the NITO-
01 harness to connect as well.
• Connect the
Blue/White
wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Tape off and disregard the following (13) wires, they will not be used in this application:
Blue/Pink
,
Blue/White
,
Brown
,
Gray
,
Gray/Black
,
Green
,
Green/Black
,
Green/Purple
,
Purple
,
Purple/Black
,
Light Green
,
White
,
White/Black
From the NITO-01 harness to the aftermarket radio:
• Connect the
Black
wire with a ring terminal to chassis ground.
• Connect the
Yellow
wire to the battery wire.
• If installing an ASWC-1 (sold separately), connect the
Red
wire to the accessory wire.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
Note:
Before connecting this wire, also refer to the “AX-CAM6V 12-volt to 6-volt” converter section
.
• Connect the
Light Green
wire to the parking brake wire.
• If retaining the factory AUX-IN jack, connect the
Red
&
White
RCA jacks to the AUX input.
• If retaining the factory backup camera, connect the
Yellow
RCA jack to the reverse camera
input. Please reference “Reverse camera operation” on page 4 if retaining the camera.
12-pin ASWC-1 harness & 3.5mm jack:
• This 12-pin ASWC-1 harness & 3.5mm jack are to be used with an
ASWC-1
(sold separately)
to retain steering wheel audio controls. If the
ASWC-1
is not being used, disregard this
harness and 3.5mm jack. If it is to be used, please refer to the
ASWC-1
instructions for radio
connections and programming. Disregard the harness that comes with the
ASWC-1
.
AX-CAM6V 12-volt to 6-volt converter:
• Connect the
Black
wire to chassis ground.
• Connect the
Blue/Red
wire to the
Red
wire labeled “Camera Power 6V”.
• Connect the
Blue/White
wire to the
Green/Purple
wire.
Note:
The
Green/Purple
wire will connect to both the AX-CAM6V, and the aftermarket radio.
