2
CONNECTIONS
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
Note:
If installing an ASWC-1 (sold separately), there will be an accessory wire there to
connect as well.
• Connect the
Blue/White
wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
• If also installing an ASWC-1 (sold separately), connect the
Brown
wire to the
Brown
wire in
the 12-pin pre-wired ASWC-1 harness.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire.
From the GMOS-MOST-02 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Brown
wire, to the
Brown
wire from the
16-pin harness with stripped leads
.
• Disregard the
Red
wire, it will not be used in this application.
• Disregard the
Red
&
White
RCA jacks, they will not be used in this application.
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the ASWC-1 (sold separately) to retain steering wheel
audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be used,
please refer to the ASWC-1 instructions for radio connections and programming. Disregard
the harness that comes with the ASWC-1.
• Connect the
Red
wire to the
accessory wire.
• Connect the
Green/Black
wire, to the
Green/Black
wire
in the 10-pin
Black
connector
located in the steering
column. (Figure A)
(Figure A)
Green/Black wire
Continued on the next page
