3
REV. 7/6/2018 INSTGMOS-LAN-012
CONNECTIONS TO BE MADE
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
Note:
If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires from the GMOS-LAN-012 harness as well.
• Connect the
Orange/White
wire to the illumination wire. (If the aftermarket radio has no
illumination wire, tape off the
Orange/White
wire).
• Connect the
Blue/White
wire to the amp turn on wire (this wire must be connected to hear
sound from the factory amplifier).
• Connect the
Brown
wire to the mute wire of the aftermarket radio. If the radio has no mute
wire, tape it off and disregard it.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
Connect the following 4 wires ONLY if your vehicle comes equipped with a digital amplifier:
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative output.
The following (3) wires are for an aftermarket multimedia/navigation radio that provide these
wires (if not required, tape them off and disregard them):
• Connect the
Light Green
wire to the parking brake wire, if applicable.
• Connect the
Blue/Pink
wire to the speed sense wire (V.S.S.), if applicable.
• Connect the
Green/Purple
wire to the reverse wire, if applicable.
Continue on the next page
