I N S TA L L AT I O N I N S T R U C T I O N S
AXGMLN-09
K
NOWLEDGE IS
P
OWER
E
nhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
REV. 2/4/20 INSTAXGMLN-09
If you are having difficulties with the installation
of this product, contact our Tech Support line
either by phone at
1-800-253-TECH
, or email at
. Before
doing so, look over the instruction booklet a
second time and ensure that the installation was
performed exactly as the instruction booklet
is stated. Have the vehicle apart and ready to
perform troubleshooting steps before contacting
Metra/Axxess Tech Support.
Chime Level Adjustment
1.
With the vehicle on, turn it off and leave the key in the ignition. Open the driver’s door; chimes will be heard.
2
Wait 10 seconds, and then with a small flat-blade screwdriver, turn the potentiometer clockwise to raise the chime level;
counterclockwise to lower the chime level.
Note:
The potentiometer is located on the side of the interface where the 16-pin harness with stripped leads is connected to.
3.
When the chime level is at a desired level, remove the key from the ignition. This will lock the chime volume at its current level.
OnStar Level Adjustment
1.
Press the OnStar button to activate it.
2.
While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on the steering wheel to raise or lower the OnStar level.
3.
If the vehicle does not come equipped with steering wheel controls, find the
Black/Yellow
wire on the
AXGMLN-09 harness
.
4.
While OnStar is speaking, tap the
Black/Yellow
wire to ground. Once the OnStar level is set, it will stay at that level until the
Black/Yellow
wire is tapped to ground again.
ADJUSTMENTS
TROUBLESHOOTING
Resetting the AXGMLN-09 Interface
1.
The
Blue
reset button is located inside the interface, between the two connectors. The button is accessible outside the interface,
no need to open the interface.
2.
Press and hold the reset button for two seconds, then let go to reset the interface.
3.
Refer to the
Programming
section from this point.