Axxess AXDIS-VW1, Руководство по установке, Страница: 2 / 8

2
CONNECTIONS TO BE MADE
From the aftermarket radio to the AXDIS-VW1 harness:
• Connect the Black wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the
Orange
wire to it.
• Connect the Blue wire to the power antenna turn-on wire.
• Connect the
Brown
wire to the mute wire.
• Connect the White wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire.
From the aftermarket radio to the AXSWC harness:
This harness is only to be used if the vehicle is equipped with steering wheel controls or a backup camera.
• Connect the
Red
wire to the accessory wire.
• For the radios listed below, connect the female 3.5mm connector with stripped leads , to the
male 3.5mm SWC jack from the AXSWC harness. Any remaining wires tape off and disregard:
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/
White wire of the connector. Then connect the remaining steering wheel control wire,
normally Brown/White , to the Brown wire of the connector.
•
Metra OE:
Connect the steering wheel control Key 1 wire (Gray) to the
Brown
wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow
wire to the Brown wire.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
• Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack into the AXSWCH-PAR (sold
separately), and then connect the 4-pin connector from the AXSWCH-PAR into the radio .
Note: The radio must be updated to rev. 2.1.4 or higher software.
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the
Brown/White
wire of
the connector. If the radio comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.
Continued on next page