4
For the steps below, the L.E.D. located inside the interface can only be seen while active. The
interface does not need to be opened to see the L.E.D.
1.
Start the vehicle.
2.
Connect the AXDIS-TY2 harness to the wiring harness in the vehicle.
3.
The L.E.D. will initially turn on solid
Green
, then turn off for a few seconds while it auto
detects the radio installed.
4.
The L.E.D. will then flash
Red
up to (18) times indicating which radio is connected to the
interface, and then turn off for a couple of seconds. Pay close attention to how many
Red
flashes there are. This will help in troubleshooting, if need be. Refer to the L.E.D. feedback
section for more information.
5.
After a couple seconds the L.E.D. will turn on solid
Red
while the interface auto detects the
vehicle. This process should take 5 to 30 seconds.
6.
Once the vehicle has been auto detected by the interface, the L.E.D. will turn on solid
Green
indicating programming was successful.
7.
Test all functions of the installation for proper operation, before reassembling the dash.
8.
If the interface fails to function, refer to Resetting the AXDIS-TY2.
Note:
The L.E.D. will turn on solid
Green
for a moment, and then turn off under normal
operation after the key has been cycled.
Note:
Fade control will not be retained with this interface.
Audio level adjustment
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
• Once at a desired level, audio level adjustment is complete.
PROGRAMMING THE AXDIS-TY2
ADJUSTING THE AXDIS-TY2
