2
CONNECTIONS
From the aftermarket radio to the AXDIS-BW122 harness, connect the:
•
Black
wire to the ground wire.
•
Yellow
wire to the battery wire.
•
Yellow
wire (6’ long w/ fuse-holder) directly to the vehicles battery.
•
Red
wire to the accessory wire.
•
Orange
wire to the illumination wire (if applicable).
•
Blue
wire to the power antenna turn-on wire.
•
Brown
wire to the mute wire.
The following (3) wires are only for multimedia/navigation radios that require these wires.
•
Blue/Pink
wire to the VSS/speed sense wire.
•
Green/Purple
wire to the reverse wire.
•
Light Green
wire to the parking brake wire.
• Tape off and disregard the following (8) wires, they will not be used in this application:
Gray
,
Gray/Black
,
Green
,
Green/Black
,
Purple
,
Purple/Black
,
White
,
White/Black
•
Red
and
White
RCA jacks to the full range amplifier output jacks.
AXSWC harness:
This harness is only to be used if the vehicle is equipped with steering wheel controls.
• Connect the
Black
wire to the chassis ground.
• Connect the
Red
wire to accessory power.
•
For the radios listed below:
Connect the
3.5mm adapter
to the male 3.5mm SWC jack from the
AXSWC harness. Any remaining wires tape off and disregard:
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/White
wire
of the connector. Then connect the remaining steering wheel control wire, normally
Brown/
White
, to the
Brown
wire of the connector.
•
Metra OE:
Connect the steering wheel control Key 1 wire
(Gray)
to the
Brown
wire.
•
Kenwood or select JVC with a steering wheel control wire:
Connect the
Blue/Yellow
wire to
the
Brown
wire.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
•
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack into the AXSWCH-PAR (sold
separately), and then connect the 4-pin connector from the AXSWCH-PAR into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to as Key-A or
SWC-1, to the
Brown
wire of the connector. Then connect the remaining steering wheel control
wire, referred to as Key-B or SWC-2, to the
Brown/White
wire of the connector. If the radio
comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.
•
For all other radios:
Connect the 3.5mm jack from the AXSWC harness, into the jack on the
aftermarket radio designated for an external steering wheel control interface. Please refer to the
aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
