2
CONNECTIONS TO BE MADE
From the aftermarket radio to the AX-LR90082 harness:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Red
wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the
Orange
wire to it.
• Connect the
Blue
wire to the power antenna turn-on wire.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire.
• Connect the
Red
and
White
RCA jacks to the front amplifier output jacks of the aftermarket radio.
From the aftermarket radio to the ASWC-1 harness:
This harness is only to be used if the vehicle is equipped with steering wheel controls.
• Connect the
Red
wire to the accessory wire.
• The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
• For the radios listed below, connect the
female 3.5mm connector with stripped leads
, to the male
3.5mm SWC jack from the ASWC-1 harness. Any remaining wires tape off and disregard:
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/White
wire of the connector. Then connect the remaining steering wheel control wire, normally
Brown/White
, to the
Brown
wire of the connector.
•
Metra OE:
Connect the steering wheel control Key 1 wire
(Gray)
to the
Brown
wire.
•
Kenwood or select JVC with a steering wheel control wire:
Connect the
Blue/Yellow
wire to the
Brown
wire.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
•
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to
as Key-A or SWC-1, to the
Brown
wire of the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the
Brown/White
wire of
the connector. If the radio comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual provided
with the radio for assigning the SWC buttons. Contact the radio manufacturer for more
information.
•
For all other radios:
Connect the 3.5mm jack from the ASWC-1 harness, into the jack on the
aftermarket radio designated for an external steering wheel control interface. Please refer to
the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
