Axxess AX-GMLAN11-SWC, Руководство по установке

Страница: 2 / 12

AX-GMLAN11-SWC
®
2
Connections to be made
Attention!
This interface will work with models that are either factory amplified,
or non-amplified. Please follow the instructions carefully for your model vehicle.
Failure to do so will result in either no sound, or low sound. If you are unsure if
your vehicle is factory amplified or not, please contact your local dealership
.
For models without an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an AX-LCD (sold separately), there will be an accessory wire
there to connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected for
the audio controls on the steering wheel to function.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
• If the aftermarket radio has a mute wire, connect the Brown wire to it. If the mute
wire is not connected, the radio will turn off when OnStar is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (4) wires, they will not be used in this
application: Green , Green/Black , Purple and Purple/Black .
From the AX-GMLAN11-SWC harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Cut off the resistors from the
Green
,
Green/Black
,
Purple
, and
Purple/Black
wires below the heat shrink.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
• Ensure the (2) 4-pin Molex connectors are connected together.
Note:
The 4-pin to 4-pin resistor pad harness will not be used in this application.
• The Black/Yellow wire is used for OnStar level adjustment for models that
do not come equipped with steering wheel controls. Refer to the OnStar level
Adjustment section for further instructions.
• Connect the
Red
and
White
RCA jacks to the audio AUX-IN jacks of the
aftermarket radio.
• The DIN jack is to be used with the optional AX-LCD (sold separately).
• Connect the Red wire to accessory power.
Continue to 3.5mm jack steering wheel control retention