Congratulations, your vehicle will be auto-detected by the
ASWC-1.
ASWC-1 Connections
1) Connect the Black wire of the ASWC-1 to chassis ground.
2) Connect the Red wire of the ASWC-1 to a 12-volt accessory wire, one that turns on
and off with the ignition key.
3) Connect the Green/Orange wire of the ASWC-1 to pin 7 of the vehicle. Below is a
picture of what the connector in the vehicle looks like:
This is the pin view of the connector in the vehicle
4) Connect the Black/Green wire of the ASWC-1 to pin 8 of the vehicle.
5) Connect pin 6 of the vehicles harness to chassis ground. You may use the same chassis
ground as the black wire.
6) All other wires on the ASWC-1 please tape up, they will not be used.
