Axopar 28 Cabin, Руководство пользователя

Страница: 47 / 134

6. Operation
6.3. Inspecting the boat
Due to safety reasons, the below listed inspections must be carried out before and after using the boat.
6.3.1. Checklist: Regular inspection before leaving harbor
Safety
Make sure that:
• All the people onboard have life jackets.
• The wind and wave conditions do not exceed the design category of the boat.
• The dead man's switch is switched to driver.
• There is fire extinguisher(s) onboard and their approval/inspection date has not expired.
• The needed ropes and anchor are onboard.
Draining and tightness
Check that:
• There is no water in the bilge.
• All the bilge pumps are functional.
• The bilge has no signs of fuel or oil leaks.
• The deck drain system is clean and the valves are open.
• All deck hatches are tightly closed.
Electrical and engine
Check that:
• All the fuses are intact.
• The main switches are switched on.
• The batteries have enough power.
• The engine works properly.
• The engine cooling water flows as expected.
• The fuel level is sufficient.
WARNING
The specified tank capacity is not necessarily fully available, depending on the
trim and load on board. The tank should always be kept at least 20% full.
6.3.2. Checklist: After using the boat
Make sure that:
• The main switches are switched off.
• The septic tank discharge valve is closed.
• There is no water in the bilge.
Axopar 28 Cabin MY2021 Document ID: 28CMY21202012EN
Owner's Manual
© 2020 Axopar Boats Page 46
-
-