Axminster Trade AT3327B, Оригинальное руководство пользователя

Страница: 22 / 36

Setting Up the Saw
22
Setting the Fence
To make sure the guide fence is at 90˚ line up the guide
fence with the edge of the table’s ‘T’ slot, see fig 59. If you
find that the fence is out of alignment follow the steps
below:
1 Clamp down the fence by pushing the locking
lever down, see fig 60.
2 Loosen the 4 Hex bolts that secure the fence rail and
adjust until the fence is in alignment with the ‘T’ slot,
then re-tighten the bolts, see fig 61.
3 Replace the fence assembly to its original position.
Fig 59
Fig 60-61
Hex bolts
‘T’ slot
Fence
Setting the Blade Guides (above table)
Lower the upper blade guide to approximately 1
1/2”(38mm) above the table. Clamp in place. Loosen the
Hex screw (A), holding the guide assembly in place and
adjust the fore and aft position so that the leading edges
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
of the side guide bearings are approximately 2 mm
behind the gullets of the saw blade. Re-tighten the Hex
screw, see fig 62. Loosen the Hex screw (B) that clamps
the rear thrust bearing in position and adjust the thrust
bearing to approximately 2mm behind the blade,
re-tighten the Hex screw, see fig 63.
Fig 62
A
Loosen the Hex screw (A) holding one of the guide
bearings and move to approximately 0.5mm from each
side of the blade. NOTE: A sheet of A4 of photocopy
paper is approximately 0.5mm thick. Adjust the guide
bearing by turning the adjusting knob (1), until the guide
bearing is set to the correct thickness. Re-tighten the Hex
screw (A), see fig 64-65. Repeat for the other guide
bearing. Gently push the blade back against the thrust
bearing, use a scrap of wood and check that the side
bearings are still behind the teeth of the blade.
Fig 63
B
2mm behind the blade
Thrust bearing Blade