W H I T E
A X M I N S T E R
W
19
Setting the Laser...
FREEPHONE
0800 371822
Warning.
Under no circumstances should you tamper with or
modify the laser to try to increase its power output.
Dispose of spent batteries responsibly.
!
!
WARNING!!
THIS PRODUCT IS EQUIPPED WITH A
CLASS 2 LASER. DO NOT LOOK
DIRECTLY INTO THE LASER BEAM
NOTE
:
The laser is individually powered. It does not switch on/off with the
application of Mains Power. REMEMBER to switch the Laser off when you have
finished using it to conserve the batteries.The laser marker fitted to the AWMS10
consists of two units; the Laser head and its mounting, and the battery pack. (See
Figs 11 & 12)
Fig 11
Fig 12
Laser
Battery pack
Aligning the Laser
Find a piece of wide board with a flat straight edge. Using a square, mark a line at right
angles to the edge, extending across the width of the board.
(See Fig 13)
Offer the board
up to the rear fence of the Mitre Saw, lower the saw blade to the board and align the offside
or nearside of the teeth with the marked line.
(See Fig 14)
Clamp the board in this position.
Switch on the laser. Check the alignment of the laser with the line marked on the board.
(See Fig 15)
DISCONNECT THE SAW FROM THE MAINS SUPPLY
!
Square
Pencil mark
Pencil mark
Laser line
Fig 13
Fig 14
Fig 15