Axminster 107646, Оригинальное руководство пользователя

Страница: 13 / 45

Fig.11: checking fence parallelism
Note:
It's permissible for the back of the fence
to pivot outward not more than 1
⁄
64" from being
parallel to the blade. This creates a slightly
larger opening between the fence and the blade,
at the rear of the blade, to reduce the risk of
workpiece binding or burning as it is fed
through the cut. Many woodworkers
intentionally set up their fence in this manner.
Keep this in mind before adjusting your fence.
D, Install the fence scale (see Fig.12)
Fig.12 Aligning rail tape with scale pointer.
Slide the fence up against the saw blade, and lock it
in place;
place the front rail tape scale on the fence tube,
make sure it is parallel with the tube, and the“0” end
is directly under the red line on the pointer window
as shown; lightly mark the “0” location on the tube
with a pencil, then remove the fence; peel the tape
and carefully align the “0” mark on the scale with the
pencil mark you made;
If you make a mistake, loosen the screws on the
point window, slide the fence against the blade,
adjust the pointer window , so the red line on the
window is over the “0” mark on the tape, then
secure the screws;
5.4.6 Install the switch
install the magnetic switch onto the bottom left hand
side of the front rail using two M6-1x 12 hex bolts,
6mm lock washers, and 6mmflat washers, as shown
in Fig.13
Fig.13: switch install