Axminster Trade AT3352B, Оригинальное руководство пользователя

Страница: 16 / 36

SETUP/ADJUSTMENT
16
Fig 26-27-28-29
Remove the lower blade guard (6). Loosen the clamping knob
(7) and adjust the lower guide bearings (8), so they are 2mm
behind the gullets of the saw. Check the thrust bearing is
centred with the back of the blade. If not, loosen the two Hex
screws (10) to the rear of the assembly & carefully move the unit
until centred. Tighten the Hex screws (10). Adjust the guide bearings with a clearance of 0.5mm between
the blade and nip-up the clamping knobs (7). Next loosen the
thrust bearing clamping knob (9) and manoeuvre, so there’s a
1mm clearance behind the blade. Secure the clamping knob
(9). Replace the lower blade guard (6) and table insert, see fig
26-27-28-29.
6
9
7
Table Positioning Stops
Beneath the table there are two positioning stop to accurately
stet the table at 45˚ or -15˚ degrees.
1. Rotate the table at 45˚ with the hand wheel (C). Adjust bolt
(A) until the bolt rests against the table casting and lock in
place with the nut (B), see fig 30.
2. Lower the 90˚ table stop bracket (D). Rotate the table to
-15 degrees on the scale and adjust stop screw (A) so it rests
against the saw frame and tighten the nut (B), see fig 31.
Fig 30-31
Thrust bearing
Guard clamp
0.5mm
1mm
2mm
8
Adjusting knobs
10