Axminster Trade AT150PPL, Оригинальное руководство пользователя

Страница: 5 / 24

Specific Safety Instruction for Woodworking Lathes
5
1. Do not use ‘split’ workpieces.
2. Always start at the lowest speed when starting a new task.
3. Check that the tool rest is at or slightly below the centre line
of the workpiece.
4. Check the workpiece is securely mounted in the lathe before
switching on the power.
5. Rotate the workpiece by hand, to check that it is centralised,
clear of the tool rest, not ‘split’ or has loose knots.
6. Where lathes have the facility to be reversed, check the
machine is rotating in the correct direction.
7. If your lathe has the facility to run in reverse, you must ensure
that the mounting accessories (chucks, faceplates etc.) can be ‘locked’ onto the lathe mandrel and, in the case of chucks have
some form of security device to prevent them ‘unwinding’
during reverse operation.
8. Make sure your tools are stored/racked away from the
turning area of the lathe. Do not reach over a rotating
workpiece at any time.
9. Do not ‘dig in’ or try to take too large a cut.
10. Do not leave the lathe running unattended or leave
the machine until everything is stopped.
11. Some turning tools may have specific sharpening angles
that have been determined by the manufacturers; when
re-sharpening, adhere to these angles to maximise the finish
of your work.
Code 508477
Model AT150PPL
Rating Trade
Power 375W 230V
Speed 400-3,600rpm
Spindle Type ER20 Collet
Spindle Thread M24 x 1mm
Taper Tailstock 1MT
Distance Between Centres 250mm
Max Diameter over Bed 150mm
Tool Rest Stem Diameter 12.5mm
Overall L x W x H 699 x 315 x 270mm
Weight 22kg
Specification